Viewing T1/E1 Configuration and Alarm Information
Page 33-12
LossOfSignal The port has experienced a Loss of Signal (LOS), or Loss of Carrier. An LOS
event occurs after 175 contiguous pulse positions with no pulses (10
absent pulses on E1 ports). An LOS failure is cleared after the switch
observes a single pulse.
RcvLOMF This port is receiving loss of multiframe (LOMF) alarms from the far-end
port. When a far-end E1 port detects an out-of-multiframe condition, it
transmits a frame with the alarm indication bit set (in time slot 16) back to
the local E1 port. This error is similar to a yellow alarm on T1 ports.
LocalUA This port is not available possibly because a cable is not attached.
Loopback The port is currently in loopback mode. Loopback mode can be config-
ured through the temod command or dynamically activated through Facil-
ity Data Link (ANSI T1.403 and AT&T 54106) or through loopback control
codes on a T1 port.

Viewing Information for T1/E1 Ports on One Module

To view port parameters, enter the following command
tes <slot>
where <slot> is the slot number where the on which you want to view information resides.
For example, to view configuration parameters for the board in slot 5, enter
tes 5
A screen similar to following displays:
T1/E1 Port Status for slot 5
Port Type Active Alarms
===== ====== =======================================================
2 T1 NoAlarm, Loopback
3 T1 NoAlarm, Loopback
Explanations of the columns in this table are described in the section, Viewing Information
for all T1/E1 Ports in the Switch on page 33-11.