Alcatel Carrier Internetworking Solutions Switch/Router Displaying GMAP Statistics by MAC Address

GMAP
Page 21-13
Displaying GMAP Statistics by MAC Address
To display GMAP statistics for all MAC addresses, use the gmapls command. The screen
displays similar to the following:
GMAP Table
================
MAC Address Protocol Group Src Switch ID Flags Timeout(sec)
------------------------ ------------- ----------- ------------------------ ---------------- --------------------
000502:C07F11 1809B 12 0020DA:ECC770 00:00:00:00 3536
800 12 0020DA:ECC770 00:00:00:00 3536
00105A:1873B9 1809B 12 0020DA:ECC770 00:00:00:00 3536
800 23 0020DA:ECC770 00:00:00:00 3536
To limit the display, specify the MAC address. For example:
gmapls 00105A:C07F11
Fields in this table are defined as follows:
MAC Address. The MAC address of the local end station.
Group. The group(s) to which the MAC address belongs.
Protocol. The protocol associated with the group on the switch from which the information
was received. Protocol values are defined as follows:
• e0e0 or ffff — IPX over 802.3
• 8137 — IPX over Ethernet II
• 18137 — IPX over SNAP
• 28137 — any IPX encapsulation
• 800 — IP
• 809b — AppleTalk
• 1809b — AppleTalk over SNAP
• 6003 — DECNET
Src Switch ID. The MAC address of the switch from which the entry was received.
Flags. The first two bytes are not used. The third byte displays the AutoTracker flags associ-
ated with the entry on the source switch. The last byte displays the router flags associated
with this entry on the source switch.
Timeout (sec). The number of seconds remaining until this entry is deleted (unless another
GMAP message is received and then the entry is refreshed).