View Module-Level Statistics
Page 11-7
For field descriptions of the device resources column, see Setting Bandwidth Thresholds on
page 11-3 and Setting Miscellaneous Thresholds on page 11-4 above.
♦ Note ♦
When calculating percentages, the health statistics
cannot display less than one percent. If a single packet
is sent through a port, for example, the receive
resource usage is represented as one percent.
The following section describes the statistics displayed using the hdstat command.
Limit
The set threshold for this resource. You can set the resource levels using the hdcfg command.
See Setting Resource Thresholds on page 11-2 for specific procedures.
Current
The current resource usage. This number is a percentage of the total resource capacity.
1 Minute Average
The average percent of resource use for the last sixty seconds.
1 Hour Average
The average percent of resource use for the last sixty minutes.
1 Hour Maximum
The maximum percent of resource use for the last sixty minutes.

View Module-Level Statistics

To view module level statistics, type the hmstat command at a system prompt followed by the
slot number. For example, to view the statistics for a module in slot three, type the following:
hmstat 3
The following screen is displayed:
Slot 3 1 Min 1 Hr 1 Hr
Resources Limit Curr Avg Avg Max
----------------- -------- ------- -------- ------- -------
Receive 80 00 00 00 00
Transmit/Receive 80 00 00 00 00
Backplane 80 95* 00 00 00
CAM 80 00 00 00 00
/System/Health %
Statistics are displayed as percentages of the total resource capacity, and represent data taken
from the last sampling interval. If a threshold for a resources was exceeded, then that statistic
is marked with an asterisk (*). For descriptions of the monitored resources, see Setting Band-
width Thresholds on page 11-3 and Setting Miscellaneous Thresholds on page 11-4 above.