The WAN Port Software Menu
Page 28-25
If the interface was using PPP, the following screen would display:
1) Admin Status ................................................................................. UP
{(U)p, (D)own}
2) Speed in BPS ................................................................................. 1544000
3) Clocking ........................................................................................ External
{(I)nternal, (E)xternal, (S)plit}
4) Protocol Type ................................................................................ PPP
{(F)rame Relay, (P)PP(Point to Point)}
7) Receive Clock ............................................................................... Normal
{(N)ormal, (I)nverted}
8) TOS for Voice Data ........................................................................ a0
TOS Value in Hex for Voice Data, 0 to disable TOS
9) TOS for Voice Signaling Data ......................................................... 60
TOS Value in Hex for Voice Signaling Data, 0 to disable TOS
10)TOS Mask for both TOS Value .........................................................e0
TOS Mask in Hex for Type of Data
11) Signaling IP Address ..................................................................... 0.0.0.0
IP Address range
12) Signaling IP Mask .......................................................................... 255.255.255.255
IP Mask range
13) KeepAlive Up Count ...................................................................... 0
{Up Count (0..255)}
14) KeepAlive Down Count .................................................................. 0
{Down Count (0..255)}
15) KeepAlive Timeout ........................................................................ 10
{Timeout (0..255)}
16) DTR Pulse Width ............................................................................ 0
{Pulse Width (0..255)}
17) DTR Pulse Count .............................................................................0
{Pulse Count (0..255)}
♦ Note ♦
The DTR Pulse settings do not apply to T1 and E1
interfaces, and are not described below.
Admin Status
The options for the Admin Status are Enable and Disable. If Enable, the port has been enabled
and can transmit data as long as its Operational Status is also enabled. If set to Disable, the
port will not pass data, even if its physical connection is good.
Speed in BPS
This field shows the speed for the T1/E1 port. This field is for reference only.
Clocking
This field shows the type of clocking set for the T1 port. This field is for reference only.
Protocol Type
The protocol type can be set to either Frame Relay or Point to Point Protocol (PPP).
♦ Important Note ♦
A port must be set to either Frame Relay or PPP before
any other protocol-related parameters can be set.