Alcatel Carrier Internetworking Solutions Switch/Router Displaying Group Flood Limits

Setting Flood Limits
Page 17-22
Displaying Group Flood Limits
The fls command allows you to view the current flood limits set for groups. The limits are set
using the flc command. To display flood limits for all Groups, enter
fls <groupNumber>
where <groupNumber> is the number of the group for which you are viewing the flood limit.
For example, to set the flood limit on Group 2 you would specify:
flc 2
A message similar to following is shown:
Flood Limit Override for Group 2(Group Name 1) is 190000 bytes per second.
A value will only be displayed for a Group on which flc has been used to set a flood limit.
As a variation of this command, you can enter fls at the system prompt without specifying a
group number. This will return flood limit information for each group configured for this
switch.