Obtaining Status and Statistical Information
Page 29-51

Information on One Virtual Circuit

To obtain status information on a single virtual circuit, you enter the frstatus command along
with the slot number for the WSX board, the port number, and DLCI number for the virtual
circuit on which you want information, as follows:
frstatus <slot>/<port>/<DLCI>
where <slot> is the slot number where the WSX board is installed, <port> is the port number
on the WSX board, and <DLCI> is the virtual circuit identifier. For example, if you wanted to
obtain status information for the board in slot 4, port 1, DLCI 32, you would enter:
frstatus 4/1/32
This command displays a screen similar to the following:
Frame Relay Status for slot 4, port 1, DLCI 32
Admin/Oper Status: UP:UP for 0 days, 00:34:40.59
Compression Administrative Status/Operational Phase: Enabled/Operation
Frames Frames Frames Octets Octets
In Out In+Out In Out %In %Out
======= ======== ======== ======= ======= ==== =====
Total 200 250 450 20000 17000
Ethernet 100 150 250 10000 11000 50 65
802.5 0 0 0 0 0 0 0
FDDI 0 0 0 0 0 0 0
IP 0 4 4 0 2000 0 12
IPX 90 99 185 9560 3960 48 23
BPDU 10 1 11 440 40 2 <1
DE Bit 10 0 10
FECN Bit 5
BECN Bit 7
Discarded 0
Frame Relay Fragmentation Information:
DLCI Frag Size Frag Status In Frag Out frag Dropped Frag
==== ========= =========== ========= ======== ============
32 0 Disabled 0 0 0
FRF.9 Compressed Compressed Uncompressed Compression
Compression: Frames Octets Octets Ratio
========== ========== ============= ============
In 200 10000 20000 2.0:1
Out 250 15000 17000 1.2:1
In+Out 450 25000 37000 1.5:1
The top of the display provides information on the status of this virtual circuit. The Admin/
Oper Status field indicates the current Administrative and Operation Status for this virtual
circuit. The next informational field, Compression Administrative Status/Operation Phase, indi-
cates the current Administrative and Operational status for Compression Negotiation on this
VC. The Administrative Status will be either Enabled or Disabled. The Operational Phase will
be Disabled (compression negotiation not enabled), Initialization (compression negotiation in
progress), or Operation (negotiation successful, data being compressed).
The table below the status information breaks down traffic on the virtual circuit by protocol
type. Each row corresponds to a frame type, such as Ethernet or IPX. For each frame type, the
number of frames received, frames transmitted, octets received, and octets transmitted is
given. The final two columns of the table (%In and %Out) represent the total percentage of
traffic (octets, not frames) for that protocol type.