Creating a VLAN for Banyan Vines Traffic
Page 22-33
15. The following prompt displays
Enter the DSAP value in hex:
Enter bc as the destination service access protocol (DSAP) value and press <Enter>.
16. The following prompt displays:
Enter the SSAP value in hex:
Again, enter bc as the source service access protocol (SSAP) value and press <Enter>.
17. The following prompt displays:
Configure more rules for this vlan (y/n):
Enter a Y. You still need to set up a rule for SNAP traffic.
18. The following prompt displays:
Select rule type:
1. Port Rule
2. MAC Address Rule
3. Protocol Rule
4. Network Address Rule
5. User Defined Rule
6. Binding Rule
7. DHCP PORT Rule
8. DHCP PORT Rule
Enter rule type (1):
Press 3 and press <Enter>.
19. The following prompt displays:
Set Rule Admin Status to ((e)nable/(d)isable):
Type e to enable this rule.
20. The following prompt displays:
Select Protocol:
1. IP
2. IPX
3. DECNET
4. APPLETALK
5. Protocol specified by ether-type
6. Protocol specified by DSAP and SSAP
7. Protocol specified by SNAP
Enter protocol type (1):
Enter a 7 to define a protocol by SNAP and press <Enter>.
21. The following prompt displays:
Enter the SNAP value in hex
Enter 00000080c4 as the desired SNAP value and press <Enter>.