System Menu
Page 7-13

System Menu

The System menu contains two commands, fsck and newfs, for checking and deleting all files
in the flash memory. To access the System menu, enter
system
at the UI prompt.
If verbose mode is enabled, the following list of commands will be displayed automatically.
If verbose mode is disabled, press the question mark (?) to display the following list of
commands. (For information on enabling verbose mode, refer to the uic command descrip-
tion in Chapter 4, “The User Interface.”)
Command System Menu
--------------- -----------------------------------------------------------------------------------
info Basic info on this system
dt Set system date and time
ser View or configure the DTE or DCE port
mpm Configure a Management Processor Module
slot View Slot Table information
systat View system stats related to system, power and environment
taskstat View task utilization stats
memstat View memory use statistics
fsck Perform a file system check on the flash file system
newfs Erase all file from /flash and create a new file system
syscfg Configure info related to this system
uic UI configuration; change - prompt, timeout, more, verbose.
camstat View CAM info and usage
camcfg Configure CAM info and usage
hrex Enter HRE-X management command sub-menu
ver/ter Enables/disables automatic display of menus on entry (obsolete)
echo/noecho Enable/disable character echo
chpr Change the prompt for the system (obsolete, use ‘uic’ command
logging View system logs.
health Set health parameters or view health statistics
cli Enter command line interface
saveconfig Dump the cache configuration content to the mpm.cnf file.
cacheconfig Set the flag to use cache configuration only.
Main File Summary VLAN Networking
Interface Security System Services Help