UI Table Filtering (Using Search and Filter Commands)
Page 4-42
2. Type f at the More? prompt. The Filter prompt (f/) will appear automatically. At the Filter
prompt, enter the desired text pattern (remember to type the text pattern exactly as it
would appear in the UI table):
f/Lne
Press <Enter>. A screen similar to the following will be displayed:
Note that only those lines containing Lane services are now displayed on the screen. All
other table entries have been filtered from the UI.

Combining Search and Filter Commands

If you receive a More? prompt after using the Filter command, the filtered information still
exceeds the maximum number of table entries designated by the more command. To further
refine your results, you can combine the Search and Filter commands.
To combine the Search and Filter commands, type / at the Filter mode’s More? prompt,
followed by a revised text pattern of up to 80 characters. Note that you can combine the
Search and Filter commands only after you have executed a Filter command and received a
More? prompt at the bottom of the resulting page.
♦ Reminder ♦
Both the Search and Filter commands are case sensi-
tive. When using these commands, be sure to type the
text pattern exactly as it would appear in the text UI
table.
Real World Example
The following example combines the Search and Filter commands to find specific IP address
information in the ipr table. (Before using this example, be sure that the more mode is
enabled and the default is set at 22 lines. For more information, refer to page 4-38.)
Filtering .......
2 /1 /Lne /1 1 1
2 /1 /Lne /2 111 1
/ %