Resetting the System
Web
– Click System, Reset. Click the Reset button to restart the sw itch. When
prompted, confirm that you want reset the switch.
Figure 4-23 Resetting the System
CLI
– Use the reload command to restart the switch.
Console#reload 22-4
System will be restarted, continue <y/n>?
Note:
When restarting the system, it will always run the Power-On Self-Test.
Setting the System Clock
Simple Network Time Protocol (SNTP) allows the switch to set its internal clock
based on periodic updates from a time server (SNTP or NTP). Main taining an
accurate time on the switch enables the sys tem lo g to record mea ningful da tes and
times for event entries. You can also manually set the clock using the Current Time
page as described in the next section. If the clock is not set, the switch wi ll only
record the time from the factory defau lt set at t he last boot up.
When the SNTP client is enabled, the switch periodically sends a req uest for a tim e
update to a configured time server. You can configure up to three time server IP
addresses. The switch will attempt to poll each server in the configured sequence.

4-36

Web
– Click System, Renumbering.
Figure 4-22 Renumbering the Stack
CLI
– This example renumbers all units in the stack.
Console#switch all renumber
Console#
2
3
-
2
Basic Management Tasks

4