• This command is the same as
spanning-tree edge-port
, and is only included
for backward compatibility with earlier products. Note that this command may
be removed for future software versions.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#bridge-group 1 portfast
Console(config-if)#
Related Commands
spanning-tree edge-port (33-13)
spanning-tree link-type
This command configures the link type for Ra pid Spa nning Tree a nd Multi ple
Spanning Tree. Use the
no
form to restore the default.
Syntax
spanning-tree link-type
{
auto
|
point-to-point
|
shared
}
no spanning-tree link-type
• auto - Automatically derived from the duplex mode setting.
• point-to-point - Point-to-point link.
• shared - Shared medium.
Default Setting
auto
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Specify a point-to-point link if the interface can only be connected to exa ctly
one other bridge, or a shared link if it can be connected to two or more bridges.
• When automatic detection is selected, the switch derives the lin k type from the
duplex mode. A full-duplex interface is considered a point-to-point link, while
a half-duplex interface is assumed t o be on a sh ared li nk.
• RSTP only works on p oint-to-point links betwe en two bridges. If you de signate
a port as a shared link, RSTP is forbidden. Sinc e MSTP is a n extension of
RSTP, this same restriction applies.
Example
Console(config)#interface ethernet ethernet 1/5
Console(config-if)#spanning-tree link-type point-to-point
33-15spanning-tree link-type
33