Current status:
Created By : LACP
Link Status : Up
Port Operation Status : Up
Operation speed-duplex : 100full
Flow control Type : None
Member Ports : Eth1/10, Eth1/11, Eth1/12,
Console#
lacp system-priority
This command configures a port's LACP system priority. Use the
no
form to restore
the default setting.
Syntax
lacp {actor | partn er} system-priority priority
no lacp {actor | partner} system-priori ty
• actor - The local side an aggregate link.
• partner - The remote side of an aggregate lin k.
• priority - This priority is used to dete rmine link aggregation gr oup (LAG)
membership, and to identify this device to other swit ches duri ng LAG
negotiations. (Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Port must be configured with the same system priority to join the sa me LAG.
• System priority is combined with the switch’s M AC address to form the LAG
identifier. This identifier is used to indicate a specific LAG during LACP
negotiations with other systems.
• Once the remote side of a link has been estab lished , LACP op eratio nal
settings are already in use on that side. Configuring LACP settings for the
partner only applies to its administrative state, not its operat iona l state, an d
will only take effect the next time an aggregate li nk is esta blished with th e
partner.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor system-priority 3
Console(config-if)#
28-4
Link Aggregation Commands
28