Leave or LeaveAll message has been issued, the ap plican ts ca n rejoin b efore the
port actually leaves the group. (Range: 60-3000 centiseconds; Default: 60)
• GARP LeaveAll Timer13 – The interval between sending out a LeaveAll query
message for VLAN group participants and the port leaving the group. This interval
should be considerably larger than the Leave Time to minimize the amount of traffic
generated by nodes rejoining the group.
(Range: 500-18000 centiseconds; Default: 1000)
• Mode – Indicates VLAN membership mode for an interf ace. (Defau lt: Hybrid)
-
1Q Trunk
– Specifies a port as an end-point for a VLAN trunk. A trunk is a direct
link between two switches, so the port transmits tag ged fr ame s that id entif y the
source VLAN. Note that frames belonging to the port’s default VLAN (i.e.,
associated with the PVID) are also transmitted as tagged frame s.
- Hybrid – Specifies a hybrid VLAN interface. The port may transmit ta gged or
untagged frames.
• Trunk Member – Indicates if a port is a member of a trunk. To add a trunk to the
selected VLAN, use the last table on the VLAN Static Table pag e.
Web
– Click VLAN, 802.1Q VLAN, Port Configuration or Trunk Configuration. Fill in
the required settings for each interface, click Apply.
Figure 11-7 VLAN Port Configuration
11-11
IEEE 802.1Q VLANs
11