Default Setting
auto
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the devic e connected to the serial
port. Some baud rates available on device s connected to the p ort might not b e
supported. The system indicates if the spee d you selecte d is not support ed. If
you select the “auto” option, the switch will autom atically dete ct the baud rate
configured on the attached terminal, and adjust the speed ac cordingly.
Example
To specify 57600 bps, enter this command:
Console(config-line)#speed 57600
Console(config-line)#
stopbits
This command sets the number of the stop bits transm itte d per byte . Use th e no
form to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#
disconnect
This command terminates an SSH, Telnet, or console connection.
Syntax
disconnect
session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
23-24
System Management Commands
23