Setting the Switch’s IP Address (IP Version 4)

Web
– Click System, Bridge Extension.
Figure 4-3 Displaying Bridge Extension Configuration
CLI
– Enter the following command.
Console#show bridge-ext
Max support VLAN numbers: 4096
Max support VLAN ID: 4093
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: No
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#
Setting the Switch’s IP Address (IP Version 4)
This section describes how to configure an initial IPv4 interface for management
access over the network. This switch supports both IPv4 and I Pv6, an d can be
managed through either of these address type s. For info rmation o n config uring the
switch with an IPv6 address, see “Setting the Switch’s IP Address (IP Version 6)” on
page 4-9.
The IPv4 address for this stack is obtained via DHCP by default. To manually
configure an address, you need to change the stack’s default settings to value s that
are compatible with your network. You may also need to a establish a default
gateway between the stack and management stations that exist on an other netwo rk
segment (if routing is not enabled on this stack).
You can manually configure a specific IP address, or direct the device to obtain an
address from a BOOTP or DHCP server. Valid IP addresses consist of four decimal

4-5

4
3
4
-
2