Canon MP 1000 manual Canon Canada Inc, Quebec & Maritime Provinces

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading. The termination on a loop may consist of any combination of devices subject only to the requirements that the total of the Load Numbers of all the devices does not exceed 100.

Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Information regarding authorized service facility locations can be obtained by calling the nearest Canon Service Center below.

Canon Canada Inc.

WESTERN CANADA

2828 16th Street, N.E., Calgary, Alberta T2E 7K7

Telephone: (403) 291-4350

ONTARIO

6390 Dixie Road, Mississauga, Ontario L5T 1P7

Telephone: (905) 795-2146

´

QUEBEC & MARITIME PROVINCES

10652 Côte de Liesse, Montreal, Quebéc H8T 1A5 Telephone: (514) 631-8821

Users should ensure for their own protection that the electrical ground connections power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

CAUTION

Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Contents vii