Canon MP 1000 manual Sending Fax

After scanning the document into memory, the MultiPASS 1000 dials the fax number and sends the document.

TRANSMITTING OK

❏The MultiPASS 1000 beeps once to indicate that the document has been sent successfully.

❏After the document is sent, it is erased from memory.

❏If an error occurs during sending, the MultiPASS 1000 beeps intermittently for a few seconds. If this happens, try sending the fax again.

❏The MultiPASS 1000 automatically redials if the receiving fax does not answer or if the line is busy. (You can specify the number of times it redials; see Auto Redial, on page 5-17.)

❏To stop sending before the fax is finished, press STOP. Any information stored in memory is erased.

❏If memory becomes full while scanning your document, the MultiPASS 1000 stops scanning in the document. It sends the pages in memory and then switches to direct sending to send the rest of the document.

❏If the ALARM light is flashing, make sure the error has been corrected and then press STOP. If necessary, refer to Chapter 14, Troubleshooting.

Documents

Sending Fax

Chapter 5 Sending Fax Documents 5-9