Attaching the Power Cord

C

N

Use only the power cord that came with the MultiPASS 1000. Using a longer cord or an extension cord may result in reduced voltage or malfunctions.

When unplugging the power cord, always remove it by holding the plug and not the cord.

Make sure no appliances that can cause electrical noise are on the same outlet.

Do not allow anything to rest on the power cord. Make sure the cord is located where it cannot be walked on or tripped over.

Do not overload the electrical outlet.

To attach the power cord, follow these steps:

1.Attach the power cord to the power receptacle on the MultiPASS 1000.

2.Plug the power cord into a properly grounded AC outlet (three-prong outlet).

Make sure the MultiPASS 1000 is firmly plugged in to assure proper electrical contact.

The MultiPASS 1000 has no power switch so the power is on whenever you plug in the power cord.

Because you have not installed the ink cartridge yet, the ALARM light blinks and the LCD displays REINSTALL CARTRIDGE. Be sure to install the ink cartridge next.

2-22Getting Started

Chapter 2

Page 44
Image 44
Canon MP 1000 manual Attaching the Power Cord, 22Getting Started