Chapter 2 Installing the Cisco ONS 15501
DC Power Connection
Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do not stare into the beam or view directly with optical instruments. Viewing the laser output with certain optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye hazard. Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure.
To connect the
Step 1 Connect the input optical fiber cable to the input connector (see Figure
Step 2 Connect the output optical fiber cable to the output connector (see Figure
Figure 2-2 Cisco ONS 15501 Optical Connections
1 | 2 |
|
|
|
|
|
|
| |
| POWER |
|
|
|
| FAIL |
| ||
| LOS |
|
|
|
INVISIBLE LASER RADIATION. |
|
|
|
|
DO NOT VIEW DIRECTLY WITH |
|
|
|
|
OPTICAL INSTRUMENTS. | Cisco ONS 15501 |
|
|
|
CLASS 1M LASER PRODUCT. | ALARM OUT | LAN |
| |
|
|
|
68379
3 | DC connectors shown | |
with cover removed | ||
|
1
2
Output monitor | 3 Output connector |
Input connector
DC Power Connection
The section describe how to ground the chassis and then connect DC power to it.
Caution Check the power at your site to ensure that you are receiving clean power (free of spikes and noise). Install a power conditioner, if necessary, to ensure proper voltages and power levels in the source voltage.
Caution Use only the hardware provided with the Cisco ONS 15501. Failure to use the provided hardware may result in unintended damage. If hardware is lost, contact Cisco Systems for a replacement.
Caution The protective cover for the DC power terminals should be installed at all times when the equipment is energized, except for any necessary maintenance or troubleshooting.
| Cisco ONS 15501 User Guide |
|
