4-39
Cisco ONS 15501 User Guide
78-14134-02, Release 2.0
Chapter4 Command Reference
restore
restore
To restore the system and network settings of the control module, including all passwords, to the
manufacturer’s default settings, use the resto re command.
restore
Syntax Description
Defaults None
Command Types Changes configuration
Command Modes No password is required.
Command History
Usage Guidelines This command can be used only from a serial port, not in a Telnet session.
Once connected to the serial port, the user must press the Enter key within 15 seconds after the password
prompt appears following a system reboot.
The command resets the user pas sword to edfa.
The command does no t reset any of the modul e settings; reset meantrig must be used for that purpose.
The user is recommended to reboot the system after utilizing this command ; the default settings ar e not
activated until the system is reboote d.
The restore command does not show up when the help command is entered, because the resto re
command is only a valid command during the first 15 seconds after a reboot.
This command has no other arguments or keywords.
Release Modification
EDFA 1.0 This command was introduced.