Cisco Systems 15501 manual Setoutsigpwrtrig, Setoutsigpwrmean

Chapter 4 Command Reference

setoutsigpwrtrig

setoutsigpwrtrig

To set the output signal alarm trigger level, use the setoutsigpwrtrig command.

setoutsigpwrtrig trigger

Syntax Description

Defaults

Command Types

Command Modes

trigger Specifies the desired output signal alarm trigger level.

20.00 dBm

Changes configuration

Master password protected

Command History	Release	Modification
	EDFA 1.0	This command was introduced.

Usage Guidelines

Examples

The output signal alarm trigger is measured in dB. See Table 1-2 on page 1-2for the minimum and maximum values. If a value entered falls outside of this acceptable range, the command will be ignored and have no effect.

The following example shows how to set the output signal alarm trigger level.

edfa > setoutsigpwrtrig 18.00

Related Commands	Command	Description
	outsigpwr	Displays the calculated output signal power.
	outsigpwrmean	Displays the output signal alarm mean level.
	outsigpwrtrig	Displays the output signal alarm trigger level.
	resetmeantrig	Resets the signal gain and alarm mean level, gain alarm trigger level, optical
		input alarm mean level, optical input alarm trigger level, output signal alarm
		mean level, output signal alarm trigger level, internal case temperature
		alarm mean level, and internal case temperature alarm trigger level to the
		manufacturer’s default settings.
	setoutsigpwrmean	Sets the output signal alarm mean level.

	Cisco ONS 15501 User Guide
4-46	78-14134-02, Release 2.0