Chapter 4 Command Reference

setinpwrmean

setinpwrmean

To set the optical input alarm mean level, use the setinpwrmean command.

setinpwrmean mean

Syntax Description

Defaults

Command Types

Command Modes

mean

Specifies the desired optical input alarm mean level.

 

 

–20.00 dBm

Changes configuration

Master password protected

Command History

Release

Modification

 

EDFA 1.0

This command was introduced.

 

 

 

Usage Guidelines

Examples

The optical input alarm mean is measured in dBm. See Table 1-2 on page 1-2for the minimum and maximum values. If a value entered falls outside of this acceptable range, the command will be ignored and have no effect.

The following example shows how to set the optical input alarm mean level.

edfa > setinpwrmean -28.00

Related Commands

Command

Description

 

inpwr

Displays the measured optical input power.

 

 

 

 

inpwrmean

Displays the optical input alarm mean level.

 

 

 

 

inpwrtrig

Displays the optical input alarm trigger level.

 

 

 

 

resetmeantrig

Resets the signal gain and alarm mean level, gain alarm trigger level, optical

 

 

input alarm mean level, optical input alarm trigger level, output signal alarm

 

 

mean level, output signal alarm trigger level, internal case temperature

 

 

alarm mean level, and internal case temperature alarm trigger level to the

 

 

manufacturer’s default settings.

 

 

 

 

setinpwrtrig

Sets the optical input alarm trigger level.

 

 

 

 

Cisco ONS 15501 User Guide

4-42

78-14134-02, Release 2.0

Page 82
Image 82
Cisco Systems 15501 manual Setinpwrmean, Inpwr