Chapter3 Managing ITP Networks Using SGM
Working with Nodes
3-100
Cisco Signaling Gateway Manager User Guide
78-15589-01
–
Unconfigured
–
SNMP Timeout
–
Device is unreachable, possibly wrong community string
–
Not ITP Device
–
Not Configured for ITP
–
MIB Data Error
–
SNMP Exception
–
SignalingPoint Inactive
–
Linkset Inactive
–
Link Congested
–
Link Send Utilization Threshold Exceeded
–
Link Receive Utilization Threshold Exceeded
–
Link Local Interface Inactive
–
Link Remote Interface Inactive
–
Link Inactive
If the cell is too small to show all of the status reason, place the cursor over
the cell to see the full status reason in a mouse over help popup.
The status reasons are listed in order of decreasing magnitude. If two or more
reasons apply, the reason of greatest magnitude is displayed.
If the status reason is Unsupported Configuration, correct the configuration
and enter the sgm cleandiscover command to delete all current network data
and begin a clean discovery of the ITP network. If the status reason is still
Unsupported Configuration, enter the sgm clean command to restore the
SGM server to a “clean” state, such as would exist after a new installation of
SGM. For more information on the use of these commands, see the “SGM
Commands and Descriptions” section on pageB-2.
Signaling Points Tab: Linksets
To view information about the linksets that are associated with the selected node,
select the Signaling Points tab. SGM displays the linksets in the top table, and the
links in the bottom table.