Chapter3 Managing ITP Networks Using SGM
Working with Nodes
3-96
Cisco Signaling Gateway Manager User Guide
78-15589-01
The status reasons are listed in order of decreasing magnitude. If two or more
reasons apply, the reason of greatest magnitude is displayed.
If the status reason is Unsupported Configuration, correct the configuration
and enter the sgm cleandiscover command to delete all current network data
and begin a clean discovery of the ITP network. If the status reason is still
Unsupported Configuration, enter the sgm clean command to restore the
SGM server to a “clean” state, such as would exist after a new installation of
SGM. For more information on the use of these commands, see the “SGM
Commands and Descriptions” section on pageB-2.
The “Viewing Detailed Information for a Link” section on page 3-175
displays additional information about the causes of link failures.
The “Viewing Detailed Information for a Linkset” section on page 3-42
displays additional information about the causes of linkset failures.
Viewing Detailed Information for a Node
SGM can display detailed information about a selected node, including its CLLI
code, point code, status, and other information.
To display detailed information for a node, use one of the following procedures:
•Select Nodes in the left pane of the SGM Main Window, right-click a node in
the right pane, then select View>Configuration Details in the right-click
menu.
•Select the turner beside Nodes in the left pane of the SGM Main Window,
then select a node.
SGM displays the Node Details Window (Figure3-24).