3-193
Cisco Signaling Gateway Manager User Guide
78-15589-01
Chapter3 Managing ITP Networks Using SGM
Working with Links
–
Link Receive Utilization Threshold Exceeded
–
Link Local Interface Inactive
–
Link Remote Interface Inactive
–
Link Inactive
If the cell is too small to show all of the status reason, place the cursor over
the cell to see the full status reason in a mouse over help popup.
The status reasons are listed in order of decreasing magnitude. If two or more
reasons apply, the reason of greatest magnitude is displayed.
If the status reason is Unsupported Configuration, correct the configuration
and enter the sgm cleandiscover command to delete all current network data
and begin a clean discovery of the ITP network. If the status reason is still
Unsupported Configuration, enter the sgm clean command to restore the
SGM server to a “clean” state, such as would exist after a new installation of
SGM. For more information on the use of these commands, see the “SGM
Commands and Descriptions” section on pageB-2.
Status Summary Tab: Local IP Address Information (SCTP Links Only)
To view local IP address information for the selected SCTP link, select the Status
Summary tab.
The Local IP Address Information sub-section displays the following information
for the selected link:
•IP Address—Local IP address associated with the link.
•Status—Current status of the IP address. Possible values are:
–
Active (green ball)—The IP address is currently fully functional.
–
Inactive (red ball)—The IP address is not currently functional.