Chapter3 Managing ITP Networks Using SGM
Working with Nodes
3-120
Cisco Signaling Gateway Manager User Guide
78-15589-01
Trap Host Configuration
To view all trap settings for the selected node, as well as all hosts and port
numbers to which the node sends traps, select the Trap Host Configuration tab.
If you have implemented SGM User-Based Access, this option is available to
users with authentication level System Administrator (Level 5) and higher.
The Trap Host Configuration table displays the following information for the
selected node:
•Current Poll Interval—Poll interval used to collect data for the table.
•Last Poll—Time the last poll was run. This field initially displays the phrase
Polling device. After the first polling cycle, SGM populates this field with the
actual time of the last poll.
•Release 2 Trap Settings—Indicates whether the following ITP release
12.2(4)MB4 trap settings are enabled:
–
SCTP Remote Address Change
–
Linkset State Change
–
Link State Change
–
Link Congestion State Change
–
Link Receive Utilization Change
–
Link Send Utilization Change
–
Route State Change
–
GTT MAP State Change
•Release 3 Trap Settings—Indicates whether the following ITP release
12.2(4)MB5 through 12.2(4)MB9a trap settings are enabled:
–
ASP State Change
–
AS State Change
–
SGMP State Change
This column might not be displayed if the ITP does not support ITP release
12.2(4)MB5 through 12.2(4)MB9a traps.