3-159
Cisco Signaling Gateway Manager User Guide
78-15589-01
Chapter3 Managing ITP Networks Using SGM
Working with Signaling Points
•Link—Name of the link associated with the event. If there is no link
associated with the event, None is displayed.
•Message—Text of the message.
You can customize this field. See the “Modifying the SGM Event
Configuration File (SolarisOnly)” section on page 5-26 for more
information.
ITP Access Lists Tab
To view information about all access lists associated with the selected signaling
point, select the ITP Access Lists tab.
For each linkset associated with the selected signaling point, the ITP Access Lists
section displays the following information:
•Current Poll Interval—Poll interval used to collect data for the table.
•Last Poll—Time the last poll was run. This field initially displays the phrase
Polling device. After the first polling cycle, SGM populates this field with the
actual time of the last poll.
•Linkset—Name of the linkset for which access lists are being displayed.
•In—Inbound access lists for the linkset. If the linkset has no inbound access
lists, this field displays None.
•Out—Outbound access lists for the linkset. If the linkset has no outbound
access lists, this field displays None.
•List #—Access list number configured on the node and applied to the linkset.
ITP uses access list numbers 2700 through 2799.
•Access List—List of commands in the access list.
Route Detail Tab
To view detailed information about routes associated with the selected signaling
point, including dynamic and shadow routes, select the Route Detail tab.
The Route Detail table displays the following information for the selected
signaling point:
•Current Poll Interval—Poll interval used to collect data for the table.
•Last Poll—Time the last poll was run. This field initially displays the phrase
Polling device. After the first polling cycle, SGM populates this field with the
actual time of the last poll.