Cisco Systems 78-15589-01 Viewing CPU Statistics for a Node

3-121
Cisco Signaling Gateway Manager User Guide
78-15589-01
Chapter3 Managing ITP Networks Using SGM
Working with Nodes
•Release 4 Trap Settings—Indicates whether the following ITP release
12.2(4)MB10 trap settings are enabled:
– Linkset State Change
– Link State Change
– Link Congestion State Change
– Link Receive Utilization Change
– Link Send Utilization Change
– Route Destination State Change
– Route Mgmt. State Change
– Route Table Load
– GTT MAP State Change
– GTT Table Load
– ASP Congestion Change
– SGMP Congestion Change
This column might not be displayed if the ITP does not support ITP release
12.2(4)MB10 traps.
•IP Address—IP address of a host to which the node sends traps.
•Port—Port to which the node sends traps.
•Trap Version—Trap version sent to this IP address and port.
•Community String—SNMP community name used by the node for read
access to the information maintained by the SNMP agent on the ITP.
Viewing CPU Statistics for a Node
SGM enables you to display the CPU utilization percentage for a node as a
function of time. SGM displays one CPU Utilization Percentage chart for each
active Route Switch Processor (RSP) CPU.
To display CPU Utilization Percentage charts for a node, right-click a node in a
window, then select View> Real-Time Data and Charts from the right-click
menu. (This option is available only if SGM can poll the node.) SGM displays the
SGM Real-Time Statistics: CPU Statistics window (Figure3-26).