Cisco Systems IPMUX-1E operation manual IPmux-1E Configuration, Isdn Configuration

IPmux-1/1EInstallation and Operation ManualAppendix E Configuration Menus

Table E-13. T1 Configuration Parameters (Cont.)

Parameter	Possible Values	Remarks
Cond. CAS first 2.5	0 to F (ESF)	2 or 4 Bit Code applied (during the first 2.5 seconds) to
sec Pattern	0 to 3 (D4)	AB(D4) or ABCD (ESF) bits (relevant in CAS mode only)
	FF	when fault conditions occur. After the first 2.5 seconds
		the code specified in ‘Cond. CAS (ABCD) pattern’ is
		applied. ABCD conditioning pattern can be applied
		toward the IP path when loss of signal, loss of frame or
		AIS detected at the T1 line. Conditioning pattern can
		also be applied toward the T1 line when packet receive
		buffer overrun or underrun occurs. When configuring
		FF to this function, this parameter is ignored and the
		CAS pattern applied in the first 2.5 seconds is the same
		as defined in ‘ Cond. CAS (ABCD) pattern’.
		Note: This field does not appear if “Unframed” is
		selected in the Line Type field or if CAS Disable is
		selected.
		Default: FF

E.5 IPmux-1E Configuration

IPmux-1E automatically detects whether the interface is ISDN or Analog, and the appropriate menu appears (see Figure E-26and Figure E-28).

ISDN Configuration

Main Menu		ISDN CONFIGURATION
↓
	1.	Interfaces Mode	Terminal
2. Configuration (ISDN)
↓	2.	Transmit Clock Source	Adaptive
2. ISDN Configuration
	3.	Channel Configuration	>
	ESC. Exit
	Select item from the menu.

Figure E-26. ISDN Configuration Menu

IPmux-1E Configuration E-23