Cisco Systems IPMUX-1 Default 0.0.0.0 not configured, To 300 milliseconds, None, Secondary, Yes

Appendix E Configuration Menus		IPmux-1/1EInstallation and Operation Manual
TDM Bytes in Frame (x48	1 to 30	Allows you to set the UDP payload length – this
bytes)		parameter enables reduction of Ethernet throughput
		(detailed explanation in Chapter 1).
		Default payload: single payload (1)
Table E-20. Bundle Connection Parameters: Static Mode (Cont.)
Parameter	Possible Values	Remarks
Connection Status	Enable	Connection enabled
	Disable	Frames will not be sent from this connection
Destination IP Address	0.0.0.0 to	IP address of the destination device
	255.255.255.255
Next Hop	0.0.0.0 to	Use the next hop parameter when the Destination IP
	255.255.255.255	address is not in the device subnet. In such cases the
		Ethernet frame is sent to the next hop IP. If it is not
		configured, the default gateway is used.
		Default: 0.0.0.0 (not configured)
		Note: The next hop IP must be in the device subnet.
Destination Bundle	E1: 1 to 496	Bundle number in the destination device
	T1: 1 to 384
Jitter Buffer	3 to 300 milliseconds	Desired depth of the jitter buffer (PDVT buffer).
	(ms)	Default: 300 (10 x ∝s), i.e. 3 msec
OAM Connectivity	Enable	The device starts transmitting at full rate after it
		detects an active, properly configured, Ipmux on the
	Disable	other side of the line.
		If the Redundancy Type in the Protection Switching
		menu is set to 1:1, OAM Connectivity must be set to
		Enable.
		Default: Disable
Redundancy Function	None, Secondary,	The bundle with Bundle ID value 2 (see first entry in
	Primary	this table) must be configured as secondary.
VLAN Tagging	Yes	For an explanation of VLAN tagging see Chapter 1.
	No
VLAN ID	0 to 4095	Default: 1
VLAN Priority	0 to 7	Default: 7

E-30 Connection Configuration: Static Mode