Cisco Systems IPMUX-1E operation manual Bundle Connection Status Parameters

IPmux-1/1EInstallation and Operation Manual Chapter 4 Troubleshooting and Diagnostics

		Table 4-6. Bundle Connection Status Parameters
Parameter	Description
Destination IP	The IP address of the opposite IPmux, to which the bundle is destined.
Address
Next Hop MAC	Layer 2 Applications: the MAC address displayed is the MAC address of the remote IPmux.
Address	Layer 3 Applications: the MAC address displayed is the MAC address of the connected Router.
Connectivity	Disabled: No activity in the channel. The channel is disabled.
Status
	OK: Both the remote and the local IPmux receive Ethernet frames, (however, there may be problems such as sequence errors, underflows, overflows, as
	explained below).
	Local Fail: The loacal IPmux does not receive Ethernet frames.
	Remote Fail: The remote IPmux does not receive Ethernet frames.
	Unavailable: The remote Ipmux does not reply to OAM messages (only applicable when OAM is enabled).
	Validation Fail: The remote Ipmux replies, but there is a configuration error (only applicable when OAM is enabled).
	Standby: Redundant bundle is OK and wiaitng for redundancy switching (only applicable when Redundancy is enabled).
	TDM Fail: There is LOS/LOF at the TDM side (only applicable when Redundancy is enabled).
	Note: While under Disable or Local Failure or Remote Failure status, the statistic counters will be inactive.

Performance Monitoring and Troubleshooting Statistics4-21