Cisco Systems IPMUX-1E operation manual Analog Channel Configuration

Appendix E Configuration MenusIPmux-1/1EInstallation and Operation Manual

Analog Channel Configuration

Main Menu			CHANNEL CONFIGURATION
	↓	1.	Channel Number	1
2.	Configuration (Analog)
	↓	2.	Channel Status	Enable
2.	Analog Configuration	3.	Rx Gain	-4dBm
	↓
3.	Channel	4.	Tx Gain	0dBm
Configuration
		5.	Testing	Disable
		6.	Echo Cancellation Status	Disable
		ESC. Exit
		Select item from the menu.

Figure E-29. Channel Configuration Menu

Table E-17. Analog Configuration

Parameter	Possible Values		Remarks
Channel Number	1,2,3,4		Selects channel to be configured
Channel Status	Enable		Channel is enabled
	Disable		Channel is disabled
Rx Gain	-10, -8, -6, -4, -2, 0, 1, 2, 3, 4, 5	(dBm)	Sets the gain towards the phone
Tx Gain	-10, -8, -6, -4, -2, 0, 1, 2, 3, 4, 5	(dBm)	Sets the analog gain as transmitted
			from the phone to configure the
			analog receiver dynamic range
Testing	Tone Injection		1 kHz tone is injected towards the
			local phone
	Remote Loopback		A remote loopback analog signal is
			set for IPmux-1E FXS/FXO/E&M
	Disable
Echo Cancellation Status	Enable, Disable		Selectable only with echo
			cancellation module

E-26 IPmux-1E Configuration