Cisco Systems IPMUX-1E operation manual Connection Configuration Dynamic CAS Mode

Appendix E Configuration MenusIPmux-1/1EInstallation and Operation Manual

Table E-21. Protection Switching Configuration Parameters (Cont.)

Parameter	Possible Values	Remarks
Force Connection	Disable, Primary,	Valid only if primary and secondary bundles have
	Secondary	been defined
Recovery	No (Non-Revertive),	Valid only if primary and secondary bundles have
	Yes (Revertive)	been defined
Wait-To-Restore Time	10 to 99	Valid only if primary and secondary bundles have
		been defined

Note For the first 10 seconds after a switch between bundles, switching back is disabled – even if a threshold is exceeded.

Main Menu

↓

2.Configuration

↓

3.Connection Configuration

Note

Note

E.7 Connection Configuration: Dynamic CAS Mode

To Configure the Connection:

1.Select 1 to enter the Connection Mode. Use the <Space bar> to select Dynamic CAS and then press <Enter>.

For Dynamic CAS: The E1/T1 Signaling Mode must be configured as CAS Enable.

2.Enter the Bundle Connection Configuration data (described later in this section).

The Bundle Connection Configuration menu for Dynamic CAS Mode differs from the menu used for Static Mode.

3. Enter the Activation Criterion data (described later in this section).

	CONNECTION CONFIGURATION
1.	Connection Mode	Dynamic CAS
2.	Bundle Connection Configuration	>
3.	Activation Criterion	>

ESC. Exit

Figure E-34. Connection Configuration

E-32 Connection Configuration: Dynamic CAS Mode