Chapter 1 Introduction

 

IPmux-1/1EInstallation and Operation Manual

 

 

 

 

Signal Levels

Receive: 0 to -10 dB

 

 

Transmit Balanced: ±3V ±10%

 

 

Transmit Unbalanced: ±2.37V ±10%

 

Jitter Performance

ITU-T G.823 standard

 

External Adapter

TBNC to BNC required

 

Cable

 

 

T1

Compliance

ANSI T1.403, ITU-T Rec. G.703, G.704

 

Connector

RJ-45, 8-pin

 

Data Rate

1.544 Mbps

 

Line Code

B8ZS, B7ZS, AMI

 

Line Impedance

Balanced: 100

 

Signal Levels

Receive: 0 to -10 dB

 

 

Transmit: ±2.75V ±10% at 0 to 655 ft with DSU

 

Jitter Performance

AT&T TR-62411, G.824 standards

Indicators

General

PWR

ON – power supply is OK

 

 

 

OFF – malfunction detected

 

 

RDY

ON – self-test is successfully completed

 

 

 

OFF – self-test in progress

 

 

 

BLINKS – self-test failure

 

Ethernet Port

LINK

OFF – line is not active

 

 

 

ON – line is OK

 

 

ACT

OFF – no activity

 

 

 

ON – a frame is being transmitted or

 

 

 

received on the line

 

 

100M

OFF – 10 MHz

 

 

 

ON – 100 MHz

 

 

FDX

OFF – half-duplex

 

 

 

ON – full-duplex

 

E1/T1 Port

SYNC

ON – port is synchronized (no alarm)

 

 

 

OFF – signal loss, LOF or AIS is detected

 

 

 

(local alarm)

 

 

 

BLINKS – RDI detected (remote alarm)

 

ISDN Port

SYNC

ON – ISDN BRI frame is synchronized (no

 

 

 

alarm)

 

 

 

OFF – signal loss, LOF is detected

 

FXS Port

SYNC

ON – off-hook

 

 

 

OFF – on-hook

 

 

 

BLINKS – ringing

Note: All LEDs are green and ON after power-up.

1-36

Technical Specifications

Page 65
Image 65
Cisco Systems IPMUX-1 General, On power supply is OK, OFF malfunction detected, On self-test is successfully completed