Cisco Systems IPMUX-1E operation manual Bundle Connection Configuration CESoIP Mode

Appendix E Configuration Menus IPmux-1/1EInstallation and Operation Manual

Note

Note

For CESoIP: The E1/T1 Signaling Mode must be configured as CAS Disable or the Line Type configured as Unframed.

To change the Connection Mode from Dynamic CAS to CESoIP: Change the Connection Mode to Static.

Update the E1/T1 Signaling Mode or Line Type. Change the Connection Mode to CESoIP

2.Enter the Bundle Connection Configuration data (described later in this section).

3.

The Bundle Connection Configuration menu for CESoIP Mode differs from the menus used for Static Mode and for Dynamic CAS Mode.

4. Enter the Activation Criterion data (described later in this section).

	CONNECTION CONFIGURATION
1.	Connection Mode	CESoIP
2.	Bundle Connection Configuration	>

ESC. Exit

Figure E-37. Connection Configuration

Bundle Connection Configuration: CESoIP Mode

Main Menu

↓

2.Configuration

↓

3.Connection Configuration

↓

2.Bundle Connection Configuration

VLAN ID and VLAN Priority are configurable only if VLAN Tagging is set to Yes.

	BUNDLE CONNECTION CONFIGURATION
1.	Bundle ID	1
2.	IP TOS	1
3.	Packet Delay (mSecs)
4.	Connection Status	Disable
5.	Destination IP Address	0.0.0.0
6.	Next Hop	0.0.0.0
7.	Source UDP
8.	Destination UDP
9.	Jitter Buffer	300
A. VLAN Tagging		Yes
B. VLAN ID		1
C. VLAN Priority		00
ESC. Exit

Calculated bundle throughput [BPS]: 3978080 Select item from the menu.

Figure E-38. Bundle Connection Configuration: CESoIP Mode

Parameters must be configured for each connection. To configure all parameters, first select the bundle ID and then proceed with the parameter configuration.

E-36 Connection Configuration: CESoIP Mode