Cisco Systems IPMUX-1E First define the bundle, To 63 msec, 1796 to, To 127 msec

IPmux-1/1EInstallation and Operation Manual			Appendix E Configuration Menus
Note
	•	First define the bundle.
	•	When changing the Destination IP Address, Next Hop, or Destination Bundle,
		the Connection Status must be set to Disable. After you save the changes,
		Connection Status can be reset to Enable.

Table E-24. Bundle Connection Parameters: CESoIP Mode

Parameter	Possible Values	Remarks
Bundle ID	1	IPmux-1 has a single bundle, with the number set
		at 1
IP ToS	0 to 255	Type of Service – sets the IP ToS field in the IP frames
		transmitted by the device.
		ToS configuration configures the WHOLE byte, since
		different vendors may use different bits to tag packets for
		traffic prioritization
		ToS assignment applies to all TDM packets leaving IPmux-1
		Default: 0
Packet Delay	1 to 63 msec	The maximum value depends on the number of time slots.
Connection Status	Enable	Connection enabled
	Disable	Frames will not be sent from this connection
Destination IP Address	0.0.0.0 to	IP address of the destination device
	255.255.255.255

Table E-24. Bundle Connection Parameters: CESoIP Mode (Cont.)

Parameter	Possible Values	Remarks
Next Hop	0.0.0.0 to	Use the next hop parameter when the Destination IP
	255.255.255.255	address is not in the device subnet. In such cases the
		Ethernet frame is sent to the next hop IP. If it is not
		configured, the default gateway is used.
		Default: 0.0.0.0 (not configured)
		Note: The next hop IP must be in the device subnet.
Source UDP	1796	Ipmux-1 has a single Source UDP number, 1796,
		which can not be changed
Destination UDP	1796 to 65534	Source UDP is the destination device
Jitter Buffer	3 to 127 msec	Desired depth of the jitter buffer (PDVT buffer)
		Default: 300 (10 x ∝s), i.e. 3 msec
VLAN Tagging	Yes	For an explanation of VLAN tagging see Chapter 1.
	No
VLAN ID	0 to 4095	Default: 1
VLAN Priority	0 to 7	Default: 7

Connection Configuration: CESoIP Mode E-37