Cisco Systems IPMUX-1E operation manual Bundle Connection Configuration Dynamic CAS Mode

IPmux-1/1EInstallation and Operation Manual Appendix E Configuration Menus

Bundle Connection Configuration: Dynamic CAS Mode

Main Menu

↓

2.Configuration

↓

3.Connection Configuration

↓

2.Bundle Connection Configuration

VLAN ID and VLAN Priority are configurable only if VLAN Tagging is set to Yes.

	BUNDLE CONNECTION CONFIGURATION
1.	Bundle ID	1
2.	IP TOS	1
3.	Active Time Slot Bytes in Frame	24
4.	Connection Status	Disable
5.	Destination IP Address	0.0.0.0
6.	Next Hop	0.0.0.0
7.	Destination Bundle	1
8.	Jitter Buffer (x10 ∝sec) rounded up 1000 ∝sec steps! 300
9.	OAM Connectivity	Disable
A. VLAN Tagging		Yes
B. VLAN ID		1
C. VLAN Priority		00
ESC. Exit
	Calculated bundle throughput [BPS]: 3978080
Select item from the menu.

Figure E-35. Bundle Connection Configuration (Dynamic CAS Mode)

Parameters must be configured for each connection. To configure all parameters, first select the bundle ID and then proceed with the parameter configuration.

Note
	• First define the bundle.
	• When changing the Destination IP Address, Next Hop, or Destination Bundle,
	the Connection Status must be set to Disable. After you save the changes,
	Connection Status can be reset to Enable.
	Table E-22. Bundle Connection Parameters: Dynamic CAS Mode
Parameter	Possible Values	Remarks
Bundle ID	1	IPmux-1 has a single bundle, with the number set
		at 1
IP ToS	0 to 255	Type of Service – sets the IP ToS field in the IP
		frames transmitted by the device

ToS configuration configures the WHOLE byte, since different vendors may use different bits to tag packets for traffic prioritization

ToS assignment applies to all TDM packets leaving IPmux-1

Default configuration: 0

Connection Configuration: Dynamic CAS Mode E-33