Cisco Systems IPMUX-1E operation manual IPmux-1 E1/T1 Configuration, E1 Configuration

IPmux-1/1EInstallation and Operation Manual Appendix E Configuration Menus

E.4 IPmux-1 E1/T1 Configuration

IPmux-1 automatically detects whether the interface is E1 or T1, and the appropriate menu appears (see Figure E-24and Figure E-25).

E1 Configuration

Main Menu

↓

2. Configuration (E1)

↓

2.E1/T1 Configuration

Note

	E1 CONFIGURATION
1.	Channel Status	Enable
2.	Transmit Clock Source	Adaptive
3.	Loopback State	Disable
4.	Rx. Sensitivity	-10dB
5.	Line Type	CRC4 enable
6.	Idle Code	7E
7.	Uplink Fail Alarm Behavior	Cond.
8.	Signaling Mode	CAS enable
9.	Cond. Data Pattern	FF
A. Cond. CAS (ABCD) Pattern		01
ESC. Exit

Select item from the menu.

Use <Esc> key or keys <1> to <9>

Figure E-24. E1 Physical Layer Configuration Menu

When “unframed” mode is selected, the Idle Code, Signaling Mode, Cond Data Pattern and Cond CAS Pattern fields are not present.

When CAS Disabled is selected, the Cond CAS Pattern field is not present.

Table E-12. E1 Physical Layer Configuration Parameters

Parameter	Possible Values	Remarks
Channel Status	Enable	Detection of LOS alarm
	Disable	No detection of LOS alarm
		Default: Enable
Transmit Clock Source	Adaptive	Adaptive clock regeneration
	Loopback	E1 recovered receive clock is used as the transmit clock
	Internal	Local clock source is used
		Default: Adaptive

IPmux-1 E1/T1 Configuration E-17