Cisco Systems IPMUX-1E operation manual Parameter Possible Values Remarks, Default 7F

Appendix E Configuration MenusIPmux-1/1EInstallation and Operation Manual

Table E-13. T1 Configuration Parameters (Cont.)

Parameter	Possible Values	Remarks
Uplink Fail Alarm		Selects notification by the agent TDM side if Ethernet
Behavior	Cond	link fails
		IPmux-1/1E sends a Cond. Error that was configured by
	AIS	the user
		IPmux-1/1E transmits unframed AIS on the E1 channel
		that was connected to the LAN
Signaling Mode	CAS enable	T1 framer is set to CAS mode and the operation mode
		to Fractional with CAS mode
	CAS disable	CAS mode is not set in the T1 framer and the operation
		mode is configured to Fractional mode
		Note: This field will not appear if “Unframed” is selected
		in the Line Type field.
		Default: CAS Enable
Cond. Data Pattern	00 to FF	Byte Code applied to timeslots when fault conditions
		occur
		Conditioning pattern can be applied to timeslots toward
		the IP path when loss of signal, loss of frame or AIS
		detected at the T1 line. Conditioning pattern can also
		be applied to timeslots toward the T1 line when packet
		receive buffer overrun or under-run occurs. In
		Unframed mode, conditioning state results in AIS
		transmission. This is applied when a LOS is detected at
		T1 line, or when the packet receive buffer is overrun or
		an underrun occurs.
		Note: This field will not appear if “Unframed” is selected
		in the Channel Type field.
		Default: 7F
Cond CAS (ABCD)	1 to F	2 or 4 Bit Code applied to AB(D4) or ABCD (ESF) bits
Pattern		when fault conditions occur
		The ABCD conditioning pattern can be applied toward
		the IP path when loss of signal, loss of frame or AIS
		detected at the T1 line. Conditioning pattern can also
		be applied toward the T1 line when packet receive
		buffer overrun or under run occur.
		Note: This field will not appear if “Unframed” is selected
		in the Channel Type field.
		Default: 1

E-22 IPmux-1 E1/T1 Configuration