Cisco Systems IPMUX-1E Default Gateway, To configure the Host IP address and IP Mask

Appendix E Configuration Menus IPmux-1/1EInstallation and Operation Manual

Host IP

Main Menu

↓

2. Configuration

↓

1.General Configuration Note

↓

1.Host IP

Note

Note

To configure the Host IP address and IP Mask:

1.On the Host IP menu, select 1 and type the IP Address.

2.On the Host IP menu, select 2 and type the IP Mask.

x

DHCP status (item 5) appears only when DHCP (item 4) is enabled.

		HOST IP
1.	IP Address	192.168.217.12
2.	IP Mask	255.255.255.0
3.	Default Gateway	0.0.0.0
4.	DHCP	Enable
5.	DHCP status	>

ESC. Exit

Select item from the menu:_

Figure E-11. Host IP Menu

x

The device reboots if you change any parameter.

To change a configured Host IP:

•Set the device to the default settings.

Frames are not sent until IP and Mask addresses are defined.

Default Gateway

Main Menu

↓

2. Configuration

↓

1.General Configuration

1. Host ↓IP Note

↓

3.Default Gateway

Default gateway defines the management Next Hop. When Next Hop is not defined for the bundle connection, the Default Gateway Address will be used.

To configure the Default Gateway:

•On the Host IP menu, select 3 and type the Default Gateway IP Address.

The Default Gateway must be in the same subnet as the Host.

E-8 General Configuration