Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-28 Connection Configuration: Static Mode
E.6 Connection Configuration: Static Mode The Connection Configuration menu changes according to the Connection Mode
selection (item 1). This section describes Static mode. For Dynamic CAS mode and
CESoIP mode, see separate descriptions later in this manual.
To configure the Connection:
1. Select 1 to enter the Connection Mode. Use the <Space bar> to select Static
and then press <Enter>.
2. Enter the Bundle Connection Configuration data (described later in this
section).
3. Select 3, enter the Secondary IP Address, and press <Enter>.
4. Select 4, enter the Secondary IP Mask and press <Enter>.
5. Enter the Protection Switching Configuration data (described later in this
section).
CONNECTION CONFIGURATION
1. Connection Mode Static
2. Bundle Connection Configuration >
3. Secondary IP Address Empty!
4. Secondary IP Mask Empty!
5. Protection Switching Configuration >
ESC. Exit
Figure E-31. Connection Configuration
Table E-19. Connection Configuration
Parameter Possible Values Remarks
Connection Mode Static, Dynamic
CAS, CESoIIP
This table describes Static Connection Mode. For Dynamic CAS
and CESoIP Connection Modes, see separate descriptions later in
this manual.
Secondary IP Address 0.0. 0.0 to
255.255.255.255
In static mode this parateter must be defined if the redundancy
function of the bundle is configured as secondary.
The secondary IP address is only used for TDMoIP traffic, ARP,
and ping reply.
The address can be on a different subnet than the host IP address
that is used for the primary bundle.
Secondary IP Mask 0.0.0.0 to
255.255.255.255
Main Menu
↓
2. Configuration
↓
3. Connection
Configuration
Note