Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-34 Connection Configuration: Dynamic CAS Mode
Active Time Slot Bytes in
Frame
24 to 64 Number of bytes, per active time slot, that will be
sent in every fram transmitted over the Ethernet. The
maximum value depends on the number of
timeslots.
Table E-22. Bundle Connection Parameters: Dynamic CAS Mode (Cont.) Parameter Possible Values Remarks
Connection Status Enable
Disable
Connection enabled
Frames will not be sent from this connection
Destination IP Address 0.0.0.0 to
255.255.255.255
IP address of the destination device
Next Hop 0.0.0.0 to
255.255.255.255
Use the next hop parameter when the Destination IP
address is not in the device subnet. In such cases the
Ethernet frame is sent to the next hop IP. If it is not
configured, the default gateway is used.
Default: 0.0.0.0 (not configured)
Note: The next hop IP must be in the device subnet.
Destination Bundle E1: 1 to 496
T1: 1 to 384
Bundle number in the destination device
Jitter Buffer 3 to 300 milliseconds
(ms)
Desired depth of the jitter buffer (PDVT buffer)
Default: 300 (10 x ยตs), i.e. 3 msec
OAM Connectivity Enable
Disable
The device starts transmitting at full rate after it
detects an active, properly configured, Ipmux on the
other side of the line.
Default: Disable
VLAN Tagging Yes
No
For an explanation of VLAN tagging see Chapter 1.
VLAN ID 0 to 4095 Default: 1
VLAN Priority 0 to 7 Default: 7