Cisco Systems IPMUX-1E Cond, CAS enable, CAS disable, Default CAS Enable, Default FF, To F

IPmux-1/1EInstallation and Operation ManualAppendix E Configuration Menus

Table E-12. E1 Physical Layer Configuration Parameters (Cont.)

Parameter	Possible Values	Remarks
Uplink Fail Alarm		Selects notification by the agent TDM side if Ethernet link fails
Behavior	Cond	IPmux-1/1E sends a Cond. Error that was configured by the
	AIS	user
		IPmux-1/1E transmits unframed AIS on the E1 channel that
		was connected to the LAN
Signaling mode	CAS enable	The E1 framer is set to CAS MF mode and the operation mode
		to fractional with CAS mode.
	CAS disable	CAS MF will not be set in the E1 framer and the operation
		mode will be configured to fractional mode.
		Note: This field will not appear if “unframed” is selected in the
		Line Type field.
		Default: CAS Enable
Cond. Data Pattern	00 to FF	Conditioning pattern can be applied to timeslots toward the IP
		path when loss of signal, loss of frame or AIS is detected at the
		E1 line. Conditioning pattern can also be applied to timeslots
		toward the E1 line when packet receive buffer overrun or
		under-run occurs. In Unframed mode, conditioning state will
		result in AIS transmission. This will be applied when a LOS is
		detected at E1 line, or when packet receive buffer overrun or
		under run occurs.
		Note: This field will not appear if “unframed” is selected in the
		Channel Type field.
		Default: FF
Cond. CAS (ABCD)	1 to F	The ABCD conditioning pattern can be applied toward the IP
Pattern		path when loss of signal, loss of frame, or AIS is detected at the
		E1 line. Conditioning pattern can also be applied toward the
		E1 line when packet receive buffer overrun or underrun occur.
		Note: This field will not appear if “Unframed” is selected in the
		Channel Type field.
		Default: 1

IPmux-1 E1/T1 Configuration E-19