Cisco Systems IPMUX-1E operation manual Alarm Traps Mask, Table E-4. Manager List Parameters

IPmux-1/1EInstallation and Operation ManualAppendix E Configuration Menus

Table E-4. Manager List Parameters

Parameter	Possible Values	Remarks
Manage IP Address	0.0.0.0. to	Sets the Manager IP address
	255.255.255.255
Link Up/Down Trap	On, Off	Link Down informs the Manager that there is a
		physical failure.
		Link Up informs the Manager that the device has
		recovered from the failure.
Alarm Trap	On	The alarm trap informs the manager of the
		occurrence of any alarm enabled in the Alarms
		Trap Mask screen. It informs the manager of both
		entry and exit from an alarm state.
	Off	No Alarm Trap will be sent regardless of the Mask
		defined in the Alarm Trap Mask screen
VLAN Tagging	Yes, No	See Chapter 1 for an explanation of VLAN tagging.
		Yes: set options 4 and 5 on the System
		Configuration Menu
VLAN ID	0 to 4095	Default: 0
VLAN Priority	0 to 7	Default: 0

Alarm Traps Mask

Main Menu

↓

2. Configuration

↓

1.General Configuration

↓

2.Management Configuration

↓

3.Alarm Traps Mask

Each of the IPmux-1/1E alarms can activate a trap toward the NMS. It is possible to enable/disable the trap operation for each one of the alarms, using the Alarm Trap Mask screen.

	ALARM TRAPS MASK
1.	Alarm ID <refer to Manual>	1
2.	Trap Status	Active

Alarm Active Traps:

Select item from the menu.

Use <Esc> key or keys <1> to <2>

Figure E-15. Alarm Traps Mask Menu

Table E-5. Alarm Traps Mask Parameters

Parameter	Possible Values	Remarks
Alarm ID	1, 2, 6, 8, 21, 26	IPmux-1/1E alarm
Trap Status	Active	Generates an alarm
	Masked	Does not send an alarm
		Default for all traps: Masked

General Configuration E-11