Nortel Networks 1000E warranty Adding a Follower Signaling Server to an IP telephony node

Configuring an IP telephony node Page 379 of 488

•Cancel. Closes the Transfer / Status pages without performing any action, and displays the Node Summary web page.

6If the Signaling Server configuration was changed on the Edit web page, reboot the Signaling Server.

End of Procedure

Adding a Follower Signaling Server to an

IP telephony node

Follow Procedure 96 to add a Follower Signaling Server to the IP telephony node in Element Manager.

Procedure 96

Adding a Follower Signaling Server to the IP telephony node in

Element Manager

Note: After software installation and reboot, the Follower Signaling Server sends out BootP requests and waits for a response. Because the Follower Signaling Server has not booted successfully before, it waits for a non-existing BootP response. Do not wait for this response; proceed to the next steps.

In Element Manager:

1Click Edit on the Node Configuration web page (see Figure 132 on page 373).

2Click Add beside the Signaling Server row.

3Enter the Follower Signaling Server data to an IP telephony node. Include the ELAN MAC address (used to answer BootP requests).

4Click Save and Transfer to save the changes and the Leader Signaling Server then obtains a copy of the node files.

5Click OK to save the node configuration to the CS 1000E and transfer the configuration to all elements.

When the file transfer is complete, the Transfer/ Status web page appears.

The Leader Signaling Server responds to the Follower Signaling Server's BootP request.

The Follower Signaling Server initializes its network interfaces.

Communication Server 1000E Installation and Configuration