Nortel Networks 1000E warranty Procedure Using Set-Based Installation

Installing and configuring IP Phones Page 433 of 488

14Enter the node number and the temporary or administrator IP Phone Installer Password.

Note 1: An asterisk is displayed for each password digit entered; the actual password is not displayed.

Note 2: If this screen times out, or if you do not successfully enter the password in three attempts, the IP Phone continues its registration process as if no entry had been made to this prompt. You can reboot the telephone and try again if more tries are needed.

The IP Phone prompts:

TN: x.x

15Enter the IP Phone’s (virtual) TN.

The IP Phone displays the logo, the date and time, and the DN keys.

16Check for dial tone and the correct DN above the display.

End of Procedure

Using Set-Based Installation

Set-Based Installation enables the delegation of telephone installation to trusted users. To have a trusted user perform this function, configure a temporary IP Phone Installer Password for the system. See “Setting administrator and temporary IP Telephone Installer passwords” on page 417.

Note: This feature can be an alternative to LD 11 or OTM to configure

IP Phones on the Call Server.

Follow Procedure 110 to use Set-Based Installation.

Procedure 110

Using Set-Based Installation

This procedure is the same as Procedure 107 on page 425, Procedure 108 on page 428, and Procedure 109 on page 430, except when the system response, displayed on the IP Phone, is as follows:

If you did not configure an IP Phone Installer Password, the IP Phone prompts:

Communication Server 1000E Installation and Configuration