Nortel Networks 1000E warranty BayStack 470 SDI connection, Media Card SDI connection

Page 274 of 488 Configuring a terminal and SDI ports

Figure 90

Maintenance to Signaling Server connection

serial

PC Maintenance

Terminal

2The COM port on the PC Maintenance terminal should be set as follows:

•Terminal type: VT100

•Speed: 19200

•Data bits: 8

•Parity: none

•Stop bits: 1

•Flow control: none

After the installation, the Signaling Server maintenance port speed can be changed. See Signaling Server: Installation and Configuration (553-3001-212).

End of Procedure

BayStack 470 SDI connection

The SDI port on the Bay Stack 470 can be used for basic configuration and maintenance. The SDI port is located on the faceplate. It is a DCE port with a default speed of 9600 bps.

Media Card SDI connection

The SDI ports on a Media Card can be used for basic configuration or maintenance. Figure 91 shows the maintenance port location on the Media Card and the Shielded 50-pin to Serial/ELAN/TLAN adapter.

553-3041-210 Standard 4.00 September 2007