Page 366 of 488 Configuring an IP telephony node

The preconfigured IP telephony configuration files from the leader Signaling Server must be imported. These files are saved on the CS 1000E as:

c:/u/db/node/nodex.cfg where x is the node number

c:/u/db/node/nodex.btp where x is the node number

IMPORTANT!

Do not attempt to alter the configuration files either manually or with

OTM’s ITG or IP Phone management. Use Element Manager only.

This chapter contains the following procedures:

Procedure 92: "Turning off browser caching in Internet Explorer" on page 367

Procedure 93: "Logging in to Element Manager" on page 370

Procedure 94: "Importing an existing node" on page 372

Procedure 95: "Reviewing and submitting IP telephony node configuration" on page 374

Procedure 96: "Adding a Follower Signaling Server to the IP telephony node in Element Manager" on page 379

Procedure 97: "Performing a datadump using Element Manager" on page 380

Before you begin

Perform a datadump

Use Element Manager to perform a datadump before making any changes to the IP telephony node. A datadump backs up both the IP telephony node configuration files and the customer database files. The datadump procedure using Element Manager is outlined in Procedure 97 on page 380.

Enable the multi-user option

Enable the multi-user option to access Command Line Interface (CLI) overlays and Element Manager at the same time. For more information about

553-3041-210 Standard 4.00 September 2007

Page 366
Image 366
Nortel Networks 1000E warranty Before you begin, Perform a datadump