Nortel Networks 1000E warranty

Installing and configuring IP Phones Page 422 of 488

2Connect one end of the CAT5 line cable to the Ethernet jack at the back of the telephone. See Figure 148 on page 421.

3Connect the other end into the IP voice network (Ethernet), using an RJ-45 connector. See Figure 149 on page 423.

WARNING

Do not plug the IP Phone into an ISDN connection. Severe damage can result. Consult the system administrator to ensure that the telephone is being plugged in to a 10/100BaseT Ethernet jack.

4Power the IP Phone with one of the following methods:

a.Using a 16V AC power adaptor, plug the AC power transformer into the nearest power outlet. Check the IP Phone User Guide for country-specific parameters.

b.Using a Power over LAN unit, connect the Power over LAN unit as shown in Figure 149 on page 423.

5Secure the telephone footstand to the base of the telephone. Use the angle adjustment grip on the top rear of the telephone to adjust the position.

Communication Server 1000E Installation and Configuration