Nortel Networks 1000E warranty 158 of 488 Connecting MG 1000T system components

Page 158 of 488 Connecting MG 1000T system components

Procedure 34

Connecting the MG 1000T Core to an MG 1000T Expansion

1Choose one of the following:

a.For point-to-point 100BaseT connectivity, go to step 2.

b.For 100BaseT connectivity over a distributed Campus Data Network, go to step 9 on page 159.

2For the MG 1000T Core connect port 1 of the SSC 100BaseT daughterboard #1 to the bulkhead connector #1 shown in Figure 39 on page 159.

Note 1: If the SSC cable is connected to bulkhead Port 1, then use Port 1 on the back of the Media Gateway. If the SSC cable is connected to bulkhead Port 2, then use Port 2 on the back of the Media Gateway.

Note 2: Port 1 on the MG 1000T Core must go to MG 1000T Expansion 1, Port 2 to MG 1000T Expansion 2, and so on.

3Connect the 100BaseT RJ-45 connector 1 on the back of the Media Gateway to the identical connector on the first Survivable MG 1000T Expansion, shown in Figure 40 on page 160.

Use the supplied NTTK34AA two-meter UTP CAT5 RJ-45 cross-over cable to connect the MG 1000T Core and the Survivable MG 1000T Expansion.

4Connect port 1 of the MG 1000T Expansion 100BaseT daughterboard #2 to the bulkhead connector #1, as shown in Figure 39 on page 159.

5For MG 1000T Expansion 2, connect port 2 of the MG 1000T Core 100BaseT daughterboard #1 to the bulkhead connector #2, shown in Figure 39 on page 159

6Connect the 100BaseT RJ-45 connector 2 on the back of the Media Gateway to the 100BaseT RJ-45 connector 1 on the second MG 1000T Expansion, shown in Figure 40 on page 160.

7Connect port 1 of the MG 1000T Expansion 100BaseT daughterboard #2 to the bulkhead connector #1, as shown in Figure 39 on page 159

553-3041-210 Standard 4.00 September 2007